Sect 9-03, Step 3. After removing vinyl at Close Out Tabs on Left Top & Left Bottom Skins, marked bend lines. This sets up Sect-04 Step 1 & 2 for each with set-back (one at 1/32, other at 1/64). Slightly staggers overlap, when assembled. Used wood block to bend initially by hand. Used rivet gun on low setting with wood block to easily finish the bend line - not too crisp, but consistent. Finished to 90 deg with hand seamer.
 |
| Bend at edge of table. |
Step 3: Trimmed 1 of 2 Rear Spars for Left elevator.