Aft Fuselage (3 hrs )
Sect 10-2 at Steps 2-6: separating J-Stiffeners, Battery Angles, etc. Lots of edge deburring... Then Sect 10-3 at Steps 1-3: repeat for more J-Stiffeners, Longerons, Bulkhead Doublers. Those Longerons are relatively thick, so edge deburring takes more time...and of course they're LONG, too.
No pics...nothing special yet.
Tuesday, May 17, 2016
Empennage
Elevator (1.5 hr )
Elevators are done ! (at least all of Sect 9 build) Finished today the Molex connectors (geesh, these are tiny) for the Trim Servo. Installed into Elevator following Steps 1-5 in Sect 9-25. Powered up via 9 volt battery - to the white leads. Reverse is simple switching - and + from battery.
Elevators are done ! (at least all of Sect 9 build) Finished today the Molex connectors (geesh, these are tiny) for the Trim Servo. Installed into Elevator following Steps 1-5 in Sect 9-25. Powered up via 9 volt battery - to the white leads. Reverse is simple switching - and + from battery.
 |
| didn't bother to switch ends for LH and RH for picture |