Flipped wing over so could read resistance at "empty" position. Confirmed OK, same 249 ohms as prior to installed in tank. Installed fuel level sensor permanently using ProSeal as gasket. Checked out via borescope - seemed OK, so installed VA261, AN913-3D fittings and plugs. Also air valve temporarily in place of CAV-110. Added balloon to fuel line -- but gotta wait for ProSeal to cure before I can pressure test for leaks.
 |
| Full empty position - just clears bottom of tank, (and is parallel) |
Started running WH00011 Wing Tip Lighting Harness from inboard to wing tip. This required extra time to read instructions 19-02 to -06 and check out parts, etc. Slow going 1st time running wires length of wing, but progress.