Jumped to Sec 31-02 since Fuselage is on its side, so easier access for some steps. Step 1-3 for blind riveting fuel line brackets - LH side completed. Needed to pay close attention, since some need washers, some w/o due to orientation of part & tool access. Used wedge tool ( ref Sec 5.4) for tight clearance. Four on LH side done, doing RH side tomorrow.
Note: Vans clarified in email response the Bearing Block Template is actually connected to Brake Pedal C Channels - just need to find and separate. Since I'd jumped into Sect 33 at midpoint to install UHMW plastic bearings, I missed two pages earlier at Sec 33-02 where this was identified. Oops ! But I now have the template... So I take it back - Vans is only 1 for 3 templates missing.