Flap Torque Arms ( 3 hrs )
Installed LH & RH Flap Torque Arms. First sanded bearing surface transition to powder coated paint on tubes. Then cleaned inside tubes, followed by priming. Used shotgun cleaning wand - works well to insure coverage with little waste. Torque Arms installed easily (certainly NOT loose), aligned perfectly. Torqued four bolts. Trial fit Flap Motor/Actuator - success !
 |
| LH Arm...outside Fuse (inside wing root area) |
 |
| Fuse still on RH side so easier to reach center area ....so flying knife edge. |
