Sanded over Aft edge of vinyl tape to reduce epoxy layer. Difficult to determine if epoxy or vinyl as sanding, but eventually tape begins to shred if too far. I found difficult to remove, but did result in good edge. Also sanded Canopy Emergency Jettison Handle at revised weld. I had a weld shop rotate handle 90 degrees ( will be vertical on panel, clearing a Garmin G5 left of center). I used extra microballoon/resin mix over weld to gain a smooth blend.
 |
| Feathered Fwd edge, and now only 1 layer tape on Aft edge. |
 |
| Nancy admiring sunset as we're putting Cesna back in hangar today. |