Breather Tube, Painted Oil Cooler Tray ( 3 hrs )
Installed Breather Tube per Steps 5-7 at 49-02. Reaching the two AN525-10R8 screws to tighten was challenging. Tried several tools, finally 1/4" drive w/ Bosch phillips head driver (type with grooves to prevent slip out) with ratchet wrench/extensions worked. Yah! Primed Oil Cooler inlet assembly parts w/ Rustoleum Hi-Temp Primer (good to 2000 deg!) followed by Rustoleum Engine Enamel (good to 500 deg). Also installed Firewall to Fuel Pump fuel line #VA-139.