Oil Cooler, etc ( 2 hrs )
Riveted nutplates to Oil Cooler Tray and Supports (Steps 1-2 at Sect 49-08). Riveted Duct Flange to Oil Cooler Sides, then sealed at 8 spots with hi-temp RTV per Steps 4-6 at 49-06. Installed VA 119 Hose between engine and VA 168 Transducer Manifold per 49-11, Steps 1-3. Need to contact Vans Tech Support to clarify OK to use aluminum AN fittings supplied vs Airflow instructions to use only steel fitting to avoid galling (ref. pic of instructions).
[ note from future: Vans OK'd using Alum fittings in Cooler on April 23 ]
 |
| temp tape with RTV applied inside to seal corners |
 |
| tah dah ! |
 |
torq wrench w/ extensions to reach fitting with 9/16" crowfoot
(other wrench on fitting to counter) |
 |
| Part No 2006X; Serial No A17-14108-11 (reference if needed) |
 |
Airflow instructions state steel fittings ONLY vs
Vans supplied alum...??? pending check with Vans Support |
