Final sanded Wheel Fairing new fillets, after 2nd pass on one cured. Per Step 2, 46A-28, sanded inside Upper and Lower Intersection Fairings where they contact Leg Fairings, then applied light coating of epoxy. Clamped Bottom Cowl Closeout to mark position, then drilled dozen #19 holes. Started machine c'sinking rivet locations so I can add nutplates.
 |
| A lot of work, but turned out well. Sanded a bit off perimeter Intersection Fairing to allow for paint thickness later. |
 |
| Really like how the fillet smooths transition. (realized after pic - the front is not all the way down w/o screws) |
 |
| done...cleaned up along separation line. |
 |
| sanded interior where contacts Leg Fairing, coated w/ epoxy. While at it, applied thin coat to exterior...will sand off most for smooth finish (had several filled spots wanted to "harden") |
 |
| After marking while installed on Fuse, re-positioned to drill. Part way done with #8 screws holding alignment |
 |
| ready to add nutplates to alum Close Out |