Added cushion clamp ( size -7) to retain extra cable at LH sub-panel forward of G3X Touch 460 panel, etc. My wife Nancy helped re-mount canopy so I could start Canopy Harness installation. Routed 40" of safety wire through LH side of Canopy per step 5 in Sect 61-03. Drilled holes for Garmin GA 26C GPS antenna in upper surface (ie dash). Since BNC connector pre-connected by Garmin to antenna, needed 3/4" hole to pass (used uni-bit). Mounted w 2 supplied screws. Tah-dah! Prepped 2 defrost fan's black & red wires per Steps 1 & 2, Sect 61-02. Routed W2128 (Wht/Brn) and W2129 (Blk) wire through canopy frame pulling pre-positioned safety wire out of aft oval hole per Sect 61-03, Steps 1-4. Protected these wires along canopy shelf via clear spiral wrap retained with cable ties.
 |
| cushion (adel) clamp securing extra harness. |
 |
| mounted GA 26C GPS antenna per Sect 61. (pre-attached BNC to wire req'd 3/4" hole to pass) |
 |
| safety wire routed from front to aft opening in LH canopy |
 |
| wires pulled through, crimped connectors, & attached to micro switch. (warns canopy not latched if RPM above 1700 RPM ) [ note: silicone sealant in oval opening yet to be added ] |
 |
| wires routed to center, gathered with LH defrost fan. |
 |
| translucent spiral wrap added, secured w/ cable ties |