Canopy Harness and Propeller & Spinner ( 3 hrs )
Added Wht/Blk wire with Molex male pin to Canopy Harness for Pin #7 position to connect to 3rd wire for Red LED and White LED strips. Added silicone at two places where canopy latch warning wires enter and exit canopy frame on LH side. Started Sect 44 Spinner & Propeller w/ Steps 1 & 2 at 44-02: Spinner Plate and Doubler Ring. Good to get back to working on aluminum vs wires.
 |
Bolts hold doubler in position to match drill #30 holes.
Marked cut line on Spinner Plate |
 |
| drilled and cleco'd |
 |
| Lots of deburring, then cut center out of Spinner Plate. |
