Loosened Spinner Plate from Prop Hub (actually removed nuts and washers so completely "off") so I could rivet Gap Fillers per Sect 44-07, Step 7. Re-assembled & torqued Hub bolts/nuts to 21 ft-lbs per Hartzell Manual Table 3-1. Trial fit Top Cowl to check gap to Spinner Plate. Marked Spinner to trim to match edge of Spinner Plate. Re-installed Spinner and sanded flush to edge of Plate completing Step 8, Sect 44-08. Now done with Propeller and Spinner!
 |
| Spinner Plate loose from Hub to enable riveting Gap Fillers |
 |
| Re-installed Spinner Plate after riveting each Gap Filler. Excess past edge of Spinner Plate yet to be removed |
 |
| checking with Top Cowl to insure clearance, and need to remove aft edge Gap Filler, as well as similar overhang on Spinner. ( after this pic, sanded Gap Filler and Spinner flush to aft edge of Spinner Plate) |