Preparing to install Tail Light per OP56, I discovered this Suntail #LN-201-1 included Molex 5 pin connector. But I only needed a 4 pin. So I switched the unused Molex 4 pin connectors supplied with the Nav Light LN-201-1 to the Tail Light, and used the 5 pin connector for the RH Wingtip Nav Light (only 1, but better than none - see Jan 28 log). Assembled the 4 pin Molex for L1082 coming from aft fuselage (part of WH00057 harness). [ note: WH00057 harness already had female pins crimped - opposite of how Vans instructions showed. Simply reversed connector and pins] Crimped male pins/assembled 4 pin Molex to Tail Light. Attached to Rudder Bottom Fairing w/ 4-40 screws (strangely, Vans did not provide these screws in kit)
 |
| Switched 5 pin from Suntail so at least 1 Wing Tip -Nav Light has a connector that matches the connector in Wing Harness |
 |
| WH00057 harness from fuselage: crimped on ring terminal for ground wire, and 4 pin connector with female pins |
 |
| Tail Light with male 4 pin Molex |
 |
| Suntail LN-201-1 Tail Light installed. Note drain hole oriented toward bottom. |