Installed CHT sensors ( Garmin part # 494-70000-00, Type K, bayonet) in cylinders 1 & 3 on right side. Crimped on #4 ring terminals to match pre-terminated sensor wires with screw/nut assembly. Layered heat shrink tubing followed by fiberglass sleeve (provided w/ sensor) to provide stability/protection. Most of my time was exploring where best to cut terminal wire at each location.
 |
| CHT sensor "kits" with instructions |
 |
| Completing CHT #1 connection (#3 connection is inside fiberglass sleeve I'm holding aside ) prior to heat shrink tubing |
 |
| Loops for strain relief. Also must keep away from exhaust tubes, yet to be installed. |
 |
| Challenge to accommodate engine movement on rubber mounts while keeping wires away from edges and hot exhaust. |
No comments:
Post a Comment