Steevo's RV14a Build Log

GAP 26 wiring ( 1 hr ) Tightened and torqued gnd bolt.  Bundled wires along with alum tubing.  Sent email with pics to G3Xexpert@garmin.co...

Gap 26 heated Pitot  installed ( 3 hrs ) Trimmed 3/16" OD alum tubes to 8 1/4" on GAP 26 heated Pitot (Garmin instructions note ...

Pitot Heater wire install & ADS-B Antenna ( 3 hrs ) Crimped open barrel male pin (ref Sect 5-21 for instructions) to red 14ga wire for...

Pitot and AOA lines ( 2 hrs ) Routed blue 1/4" OD nylon air line  for  AOA  through fuselage from wing root to IP.  Routed "...

Joystick Boots ( 2 hrs ) Per Sect 42-07, positioned joystick boot material (used mini-clamps & double sided tape), then riveted w/ AAC...

Snap Bushings for OAT cable, Pitot, & AOA lines ( 3 hrs ) Drilled 8 places with Uni-bit for SB375-4 bushings in LH seat ribs - will ro...

OAT wire routed, etc ( 3 hrs ) Routed OAT (outside air temp probe) from backside of G3X Touch display (GDU460) to center tunnel.  Required...