Steevo's RV14a Build Log: 12/06/16

I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.

But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.

Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Tuesday, December 6, 2016

Wings

Misc details on Wings ( 4 hrs )

Installed last 2 nutplates at Wing Walk Root when rec'd today from Vans (reference earlier posting - missed in QB build). Reviewed / inventoried Bag 3342 that was on BackOrder (only 2 days...?) for 14 Garmin AP Install Kit.

Buffed / primed two F1037A Bellcrank Angles (rec'd replacement yesterday, since I drilled an "oval" 1/4" hole in one), Access Hatch inside surface, Hatch Doubler, two Landing Light Mtg Brackets, and four Backing Plates. After priming, added nutplates to the light brackets and backing plates. Then finally - sprayed these flat black per Steps 2 & 3 Sect 17-05, The LED landing lights will stand out from the dark recess location along the leading edge.

Bellcrank Angles not shown.