Steevo's RV14a Build Log: 06/21/18

I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.

But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.

Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Thursday, June 21, 2018

Finish Kit and Firewall Forward Kit

Heat Shields for Bottom Cowl and Baffle Seals ( 4 hrs )

Completed Sect 45-26 Bottom Cowl Heat Shield Steps 1-8. RH side cylinders are ahead of LH side, hench heat shields are not symmetrical. For the Finish Kit, this leaves only Sect 41: Wing Attachment, and Sect 46A: Tri-Gear Leg & Wheels Fairings. So...back to Firewall Forward Kit to Sect 47: Cowl Baffles ( re-start at pp 23-30). About 1/2 done riveting on rubber baffle seals (pop rivets with large washers).

1st section done.

All 3 sections "squeeged". Edges sealed with epoxy resin.

seal sections are not labeled. So...need to check orientation
carefully...some are nearly identical but slightly different.