I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Saturday, May 11, 2019

Engine

Heat Muffs, etc ( 3 hrs )

Completed Step 6, Sect 48-05 - 2" Vent Tee.  Limited space to 1st install two Adel clamps to engine mount tubes, then very large Adel Clamps around 2" Vent.  Used safety wire to hold clamps in position.  Overall took a lot of time to get positioned correctly - and lots of various tools!   Glad that's done !
Using tool to hold clamp closed so I can
hold closed w/ safety wire
In the end, I used many tools to get  'er done.






close up showing clamps secured
And overall shot showing 2" SCAT hose routing 
Posted by at No comments:
Labels:
Subscribe to: Posts (Atom)