Steevo's RV14a Build Log: 03/26/17

I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.

But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.

Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Sunday, March 26, 2017

Wings

RH Tip ( 2 hrs )

Re-installed RH Tip - great fit and alignment (whew !). In order to install Tip Rib per next Steps 1-3 (Sect 24-04) needed to remove Tip first so I could remove aileron. Good thing I was only using about 25% of the mounting screws. Then re-installed Tip so I could align Rib into Tip while mounted to Wing. Sure glad I tied a string to the Rib first, since I managed to "drop" the Rib while position and tweaking. I would have gotten to remove the Tip again to recover the Rib deep inside Tip. Van's instructs to remove the Rib after only drilling a hole at each end, marking centerline on Rib, then re-align Rib back into position via holes drilled through Tip only. Instead I simply drilled all the holes with the Rib locked in position...way easier.