I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Friday, March 4, 2016

Empennage

March 3, Thurs.    (I'm back in shop after enjoying a month soaking up sunshine in Arizona !)

Horizontal Stab (3hrs)

Sec.  8 -02   Start of Horizontal Stab build.    Steps 1-4 done for Rear Spar with doubler and  hinge brackets (4 pairs).  I did the doubler for front spar while I was at it, too.    Lots of deburring edges (along 9ft + spar !) including all the lightening holes.   Small diameter 3M Cut and Polish wheel (1") in air drill made quick work of the holes.  A groove worn into wheel aids in slightly rounding the edges, too.

Final Drilled holes (reaming) in for doubler to spar rivets, and spar to brackets.

Posted by at
Labels: ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)