I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Monday, December 11, 2017

Finish Kit

Engine Mount ( 3 hrs )

Per Sect 38 - 37, Steps 2-7, and Sect 38, Steps 1-8 installed Guide Plates on Fuselage Rail.  Used silly putty instead of modeling clay - worked fine for Step 3.  Templates are helpful for alignment, too.   Per Sect 40 "Tricycle Landing Gear and Engine Mount", first reamed 6 holes in firewall with 3/8" reamer, then installed Engine Mount.  Three different bolt lengths used...and I re-checked length of top 2 since seemed fewer exposed threads than expected - especially vs the other 4.  All the bolts met length specs.    I'm confirming A-OK with Van's prior to torquing.
silly putty instead of modeling clay worked fine
 

ta dah...  guide plates ready
Posted by at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)