I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Monday, December 4, 2017

Finish Kit

Flap Motor Cover ( 3 hrs )

Back on Nov 30 I used extra micro-balloon/resin to smooth over the flush rivets on Aft Tunnel Cover around Fuel Control ( where doubler/spacer was attached).   Sanded today and primed - turned out really smooth with no evidence of rivets.   Completed Flap Motor Cover Ass'ly after 1st deburring & primimg.  Used 12" Back Rivet set and Backplate on bench.  Super easy, and "cleaner"  vs Van's version with round head rivets.  Also buffed then primed LH & RH Steps per Sect 42-05, Step 1.

 

 

Steps primed (covered bolt holes, since tight fit tolerance )

Posted by at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)