Steevo's RV14a Build Log: Finish Kit

I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.

But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.

Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Thursday, August 23, 2018

Finish Kit

Riveted FF00003B to -3A per Step 18 at 46A-30 (done with Sect 46A). Mounted to Bottom Cowl - great fit. Used closed cell foam from Garmin avionics packaging to create Inlet Ramp/Prop Gov Foam Seal. Vans is correct that a bandsaw works well for trimming outline per template provided. Bonded into Top Cowl with hi-temp RTV per Sect 47-30, Steps 1-6. Re-installed Prop Gov bracket assembly per Sect 43-07 [ ref: 9/64" allen wrench]. Next: installation of Empennage Fairing per Sect 12-10 to 12-13 (completed Emp Kit back in Sept 2016 - but Emp Fairing is not supplied until Finish Kit...combined with other fiberglass parts).