Steevo's RV14a Build Log: 03/17/16

I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.

But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.

Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Thursday, March 17, 2016

Empennage

Horiz Stab (4 hrs )

Sect 8-9 Step 1 & 2: Inboard Inspar Ribs riveted to Stringer and Web. Finally, beginning to put it all together starting with this sub-assembly.

Sect 8-10: Finished Steps 1 to 3. Riveted Front Spar to Ribs. (note: two center Inspar Ribs are not yet riveted to Spar pending Nose Rib assembly at same time...next section).

I tried to use Main Squeezer for all the ribs, but several configs didn't allow proper reach &/or interfered with the rib's flanges. I messed up one rivet, so after removing bad rivet, I switched to rivet gun/tungsten bucking bar...and it was easier.