Steevo's RV14a Build Log: 05/25/19

I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.

But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.

Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Saturday, May 25, 2019

Finish Kit and Avionics

Seat Belts and G3X Config ( 5 hrs )

Adjusted Seat Belt Harnesses for correct lengths for both my wife and I. Workrd on G3X configuration/set ups. Discovered LH joystick had Flap switch reversed vs RH joystick (RH agrees with panel mounted Flap switch direction). So, contacted Stein Air, who consulted with Tosten (grip source for switches and wiring). Determined I could loosen switch bezel on grip, rotate switch 180 degrees. Works correctly now. Then I discovered the AP/CWS (autopilot/control wheel steering) switch is not working on LH joystick....and Pitch trim up/down is reversed vs RH joystick (but both have same Left and Right aileron trim movement). Seems LH joystick has been assembled wrong...or connector on main harness in Fuse has a major problem. Generated 5 pages of notes for follow up with Stein Air and Tosten after Memorial Day.

After loosening, then rotating small toggle switch
on LH joystick, now operating same directions as
RH Joystick, and panel mounted Flap switch.
(replaced red cap on toggle after pic)