Steevo's RV14a Build Log: 12/08/18

I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.

But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.

Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Saturday, December 8, 2018

Avionics

Snap Bushings for OAT cable, Pitot, & AOA lines ( 3 hrs )

Drilled 8 places with Uni-bit for SB375-4 bushings in LH seat ribs - will route Pitot and AOA 1/4" nylon air lines soon. Made 4 alum brackets to hold four SB437-4 bushings to secure OAT cable passing from center tunnel to LH Wing.

forgot to take pic before 2 of 4 installed.

Yellow shows planned route for Pitot and AOA lines. Two in
spar were Vans design location, whereas I determined route
through seat ribs to wing. Blue highlights the brackets added
for OAT with bushings

bottom line is brake line (no fluid...yet). Blue and white
"lines" sketched in after pic for AOA and Pitot lines