Steevo's RV14a Build Log: 03/20/19

I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.

But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.

Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Wednesday, March 20, 2019

Engine and Firewall Forward Kit

Oil Cooler Air Valve, EarthX battery BMS ( 2 hrs )

Connected cable at air valve control arm. Used -12 size cushion clamp on Engine Mount tube to mount a -3 size to constrain cable. Added redundant collar (positioned to enable opening IF primary set screw loosens), and wrapped extra cable around arm. Overall, works great. Added spade connector to brown/blue stripe EarthX Discrete wire = "Discrete in 5" (GAD27, pin 13). Will configure as "active low". This enables BMS (battery mgmt system) to signal G3X display condition of overcharging, or over-discharging.

Full open. Note cushion clamps on engine

mount tube holding cable in position.

Fully closed.

Connected to BMS signal on EarthX battery (circled in yellow)