I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Friday, December 9, 2016

Wings

Left Wing:  Fuel Level Sensor & Wiring Harness (4 hrs )

Flipped wing over so could read resistance at "empty" position.   Confirmed OK,  same 249 ohms as prior to installed in tank.  Installed fuel level sensor permanently using ProSeal as gasket.   Checked out via borescope - seemed OK, so installed VA261, AN913-3D fittings and plugs.  Also air valve temporarily in place of CAV-110.  Added balloon to fuel line -- but gotta wait for ProSeal to cure before I can pressure test for leaks.  

Full empty position - just clears bottom of tank, (and is parallel)

Started running WH00011 Wing Tip Lighting Harness from inboard to wing tip.   This required extra time to read instructions 19-02 to -06 and check out parts, etc.   Slow going 1st time running wires length of wing, but progress.
Posted by at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)