I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Monday, April 3, 2017

Wings

RH Tip Lens completed, Magnetometer Mount ( 2 hrs )

Just 15 min to complete riveting on the 2 nutplates and re-install RH Tip Lens.  Very pleased with fit. Done with Sect 24.      Started Sect 62: Garmin Magnetometer Mount Kit ( slides in ADHARS Mount Assembly in LH Wing ), used to install Garmin GMU 22.  Deburred edges and holes, CS both sides for the double flush rivets and primed.

Holes were 1/8" too close to sides to use Microgage with countersink.  But a 12" extension was used by simply taping the CS into the female hex end.  Good fit!  Worked fine...just proceeded slowly and CHECKED often to avoid going too deep.
Posted by at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)