I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Saturday, April 14, 2018

Firewall Forward Kit

Alt Air Inlet and Oil Cooler Tray ( 3 hrs )

Match drilled six #40 holes, dimpled the 2 forward locations, then riveted Right Air Ramp Cone per Steps 10-14, Sect 47-21. Next, installed nutplate for Air Filter Cover per Steps 9-14, Sect 47-22.  Done with Snorkel, except left plastic tape over inlet at Fuel Servo for now, w/ note hanging below as reminder to remove.  Started building Oil Cooler Tray per Sect 49-06, Steps 2-7 by deburring holes and edges.
perfect fit of Cover retaining K&N Air Filter.
 


not shown, also cut 4 tubes to 3.5" for spacers
Posted by at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)