I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Saturday, July 21, 2018

Finish Kit

Front Wheel Fairing ( 3 hrs )

Aligned Front Wheel Fairing per Sect 46A-11.  Located 8 holes using spherical magnets matching those already on Bracket on inside.  Marked, then drilled #40 holes, adding cleco each hole.  Measured Standoff location, drilled 1/4" pilot hole each side per 46A-12, Step 5.  Later, will be enlarged to 1" dia to enable tow bar hookup. 
Aligned w/ aircraft centerline (drawn on floor),
and held aft end to specific height.

Spherical magnets aligned w/ same magnets on Bracket inside. 
Used to locate where to drill holes

Drilled 1/4" pilot hole for standoff access. 
Will enlarge to 1" dia to allow tow bar hookup

Posted by at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)