I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Saturday, January 19, 2019

Firewall Forward Kit - Propeller

Spinner ( 3 hrs )

Completed Sect 44-03, -04, & -05:  positioning and drilling for mounting.  Needed to trim some for clearance around prop, but template from Hartzell insured good fit (Spinner came with outline marked...slightly more forward than template, but close).   Since opaque (comes with pinholes filled) required use of spherical magnets to locate holes in Front Spinner Bulkhead.  Trimmed cut-out pieces to make Gap Filler behind Prop.  Positioned and drilled #40 holes for rivets.  Since not rotating prop (keep oil from being scraped off cylinders and cams, etc ) I had the pleasure of working from underneath Spinner - not fun, but got  'er done.
Front Spinner Bulkhead has 6 pre-punched holes.  Used
spherical magnets to determine hole location through
opaque Spinnner
6 Spherical magnets in place...ready to
mark hole centerlines and drill.


All holes drilled at Front Bulkhead, and
along rear Spinner Plate
Gap Fillers positioned and drilled for rivets


Working underneath was challenging. 

No comments:

Post a Comment