I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Tuesday, March 28, 2017

Wings

LH Tip Rib ( 4 hrs )

Finished RH Tip Rib installation with 6 blind rivets installed while mounted on wing ( best "jig" ).  Then removed Tip from Wing to install the remaining AN426  3-3.5 rivets.   Good result, so moved on to LH Tip Rib...basically repeat.  Drilled 19 #40 holes, with 6 enlarged to #33 for the MK319 blind rivets.  Countersunk all holes - all while still mounted to Wing.   Ready to deburr, prime and rivet next.   Planning to trim ends of each Tip when both are "ready".
pic from inside showing rivets and blind rivets.
Only buffed and primed flanges...so "messy" in center of rib

whew..glad this Tip is almost done...
except trimming end ~1/4 inch as marked

No comments:

Post a Comment