I've started my adventure to build a Van's Aircraft RV14a. For several years, I've been planning to build an Experimental (homebuilt) airplane - once retired.
But first, I needed to get my Pilot's License. (Kinda key !) So... first things first: I retired March 2014 from Caterpillar - and started flying lessons in the Summer of 2014. Soloed a day after Christmas, and got my Private July 2015. Shop set up, tools acquisition, and practise kits during Fall launched me into my build starting Dec 31, 2015 !

I've chosen to build the RV14a since it's about 10% larger than Van's prior models - so it fits my 6'4" frame well. Van's is well known for great value & outstanding flying qualities. It's been a no brainer decision for me. A tour of their facilities and demo flight in Oct 2013 clinched the deal. My wife - also a pilot - exclaimed after her demo flight "retire NOW so you can build one of these". The RV14a fits my mission of a good compromise between cross country & aerobatics. Plus...I fit, too.

So far, one month into building, it's been rewarding. Very challenging, but certainly a learning experience. The builder community is terrific - as is Van's tech support. I'm finished with the Vert Stab and Rudder (Jan 2016). So... with a 5 month delivery lead time, I've ordered the Quick Build Wings and Fuselage.

I hope this blog assists other new builders, just like several others have been valuable to me. Plus it will serve to document my build step by step. Please drop me a line via the "contact me" form on lower RH margin.
Update: April 2020 relocated to Wickenburg, Az to escape Illinois winters.

Tuesday, March 20, 2018

Firewall Forward

Alternator ( 3 hrs )

Installed Alternator per Sect 43-12 Steps 1-6 (ref prep in March 17 log).  Per instructions, delayed setting belt tension until Sect 51-06, after propeller installed, etc.   Safety wire took a trial run, but getting closer to "fun".  Also getting better at installing adel (or cushion) clamps using temporary safety wire, and "Cushioned Clamp Installation Pliers".  Thanks Vans Tech Support for recommending applying silicone spray to enable sliding clamps into position during assembly.



routed alternator power wire along side of engine case

double clamp on mount tube routes wire to firewall

Posted by at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)